Home
Products
Customer Support Center
Shopping Cart
Galleries
Enter Shop
Contact Us
Login
Premium Dealers
Product Updates
Customer Support Center
>
Customer Knowledge and Information Base
>
Shopping Cart
Items in Cart
0
Current Total
$0.00
How should I operate the Nano Focus Light?
Installing and Removing Batteries
To open the Nano Focus Light, hold the hand grip firmly in one hand and turn the flashlight head counterclockwise until it separates. Pull the flashlight head off. Please make sure that the light is pointed in an upward position so the contents do not fall out when opened. Take special care not to stare into the light beam which is powerful and could damage your eyes.
Gently remove the LED head by pulling it out.
Install or remove the 4 AAA Alkaline batteries carefully. Please note that this light should not be used with rechargeable batteries. Make sure that you follow the instructions diagram printed on the inside of the light. Note that there are two sets of two batteries, each set pointing in a different direction.
Replace the LED head carefully, making sure that the two protrusions on the inside of the battery compartment correspond with the two niches on the LED head. This is the only way it will fit properly.
Carefully place the flashlight head over the threads, and tighten evenly in a clockwise fashion. Do not use force and do not allow it to screw down unevenly. Take special care not to stare into the light beam which is powerful and could damage your eyes.
It is recommended to occasionally apply a slight amount of silicone grease to the black O-ring seal found on the flashlight after unscrewing the flashlight head counterclockwise.
Turning the Nano Focus Light On/Off
In order to switch the light on, carefully turn the flashlight head counterclockwise just enough for the light to turn on. Once the light is turned on, do not keep turning the flashlight head counterclockwise, or else the watertight seal of the light will be damaged.
The light is turned on and whenever a flash is fired, the LED Light’s sensor shuts the light off for a second, in order to prevent a hot spot in the image, caused by the beam of the light. After a second, when the image had been already captured, the light turns on again.
In order to switch the light back off, turn the flashlight head in a clockwise fashion to the end. Please note that there is never a need to use force when closing or opening the light or turning it on or off.
Please note: If you are turning the flashlight head more than half a turn and nothing happens, you are probably turning it the wrong way.